Kia Cadenza YG: Body (Interior and Exterior)
- Specifications
- Special Service Tools
- Troubleshooting
- Body Dimensions
- General Information
- Front Body Body Repair
- Side Body Body Repair
- Interior Body Repair
- Rear Body Body Repair
- Under Body Body Repair
- Exterior
- Fender Repair procedures
- Hood Repair procedures
- Trunk Lid Repair procedures
- Front Door Components and Components Location
- Front Door Repair procedures
- Rear Door Components and Components Location
- Rear Door Repair procedures
- Body Side Moulding Repair procedures
- Panoramaroof Components and Components Location
- Panoramaroof Repair procedures
- Mirror Repair procedures
- Cowl Top Cover Repair procedures
- Interior
- Console Components and Components Location
- Console Repair procedures
- Crash Pad Components and Components Location
- Crash Pad Repair procedures
- Roof Trim Components and Components Location
- Roof Trim Repair procedures
- Interior Trim Components and Components Location
- Interior Trim Repair procedures
- Trunk Trim Repair procedures
- Windshield Glass Components and Components Location
- Windshield Glass Repair procedures
- Rear Window Glass Repair procedures
- Bumper
- Front Bumper Components and Components Location
- Front Bumper Repair procedures
- Rear Bumper Components and Components Location
- Rear Bumper Repair procedures
- Seat & Power Seat
- Front Seat Components and Components Location
- Front Seat Repair procedures
- Rear Seat Components and Components Location
- Rear Seat Repair procedures
- Seat Belt
Description Steering Wheel Angle Sensor detects rotating direction of the vehicle. Rotating direction detected by the sensor is communicated with HECU as CAN signal involving information about the angle through CAN communication line.
Specifications ItemsSpecificationHoodTypeRear hinged, gas lifter typeFront DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemRear DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemTrunk LidTypeTorsior bar typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Suspension System
- Timing Chain Repair procedures
- New on site
- Most important about car
