Kia Cadenza YG: Exterior / Cowl Top Cover Repair procedures
| Replacement |
| 1. |
Remove the cover (B) and remove the nuts, then remove the wiper arm (A).
|
| 2. |
Detach the clips, then remove the cowl top cover (A).
|
| 3. |
Installation is the reverse of removal.
|
Replacement Outside Rear View Mirror Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Transaxle Control Module (TCM) Repair procedures
- Schematic Diagrams
- New on site
- Most important about car
