Kia Cadenza YG: Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the roof trim.
(Refer to Body - "Roof trim assembly")
3.
Disconnect the curtain airbag harness connector (A).

4.
After loosening the mounting bolts and nuts remove the curtain airbag.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts and nuts.
Tightening torque
Bolts : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Nuts : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
   
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to Body - "Roof trim assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Components

    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be deployed.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Specifications

    S

    Kia Cadenza YG 2016-2021 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0213