Kia Cadenza: Driving your vehicle / Economical operation

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Economical operation

Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive.

Each of these factors affects how many miles (kilometers) you can get from a gallon (liter) of fuel.To operate your vehicle as economically as possible, use the following driving suggestions to help save money in both fuel and repairs:

Keeping a vehicle in good operating condition is important both for economy and safety. Therefore, have an authorized Kia dealer perform scheduled inspections and maintenance.

WARNING - Engine off during motion

Never turn the engine off to coast down hills or anytime the vehicle is in motion. The power steering and power brakes will not function properly without the engine running. In addition, turning off the ignition while driving could lead to out of working power driven steering wheel and hard to control steering wheel. Keep the engine on and downshift to an appropriate gear for an engine braking effect.

Limitations of the system
The driver must be cautious in the below situations, because the system may not detect other vehicles or objects in certain circumstances. When a trailer or carrier is installed. The ve ...

Special driving conditions
Hazardous driving conditions When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: General Information


General Service Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.     The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the ...

Kia Cadenza YG 2016-2025 Service Manual: IMS Control Switch Repair procedures


Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Removal 1. Disconnect the negative (-) b ...

Copyright © www.kcadenzavg.com 2017-2025