Kia Cadenza: What to do in an emergency / If the engine will not start

Kia Cadenza YG 2016-2025 Owners Manual / What to do in an emergency / If the engine will not start

If engine doesn't turn over or turns over slowly

1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2. Check the battery connections to be sure they are clean and tight.

3. Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4. Check the starter connections to be sure they are securely tightened.

5. Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING - Push/ pull start

Do not push or pull the vehicle to start it. Push or pull starting may cause the catalytic converter to overload and create a fire hazard.

If engine turns over normally but does not start

1. Check the fuel level.

2. With the ENGINE START/STOP button in the OFF position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose.

3. Check the fuel line in the engine compartment.

4. If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.

In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Front Strut Assembly Components and Components Location


Components 1. Insulator cap2. Upper locking nut3. Self locking nut4. Insulator 5. Strut bearing6. Spring upper pad7. Strut dust cover & Bumper rubber8. Coil spring9. Spring lower pad10. Piston rod11. Strut assembly12. Spring lower seat ...

Kia Cadenza YG 2016-2025 Service Manual: IMS (Integrated Memory System) module Repair procedures


Removal 1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to Body - "Front Seat") 3. Remove the IMS module (A) after loosening 3 screws in the bottom of seat. 4. Disconnect the IMS module connector (A) and then remove the IMS module (B). Ins ...

Copyright © www.kcadenzavg.com 2017-2025