Kia Cadenza YG: Intake And Exhaust System / Intake Manifold Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Intake And Exhaust System / Intake Manifold Repair procedures

Removal and Installation
1.
Remove the surge tank.
(Refer to Intake And Exhaust System - "Surge Tank")
2.
Remove the low pressure fule line.
(Refer to Fuel System - "Fuel Line")
3.
Remove the intake manifold (A).

   
•
Cover the cylinder head intake port with a clean woven stuff or vinyl cover to prevent foreign materials from entering.
•
Make sure the engine and radiator are cool to the touch.
•
Remove radiator cap.
•
Loosen the drain plug and drain the coolant.
•
Tighten the radiator drain plug securely.
   
Drain the engine coolant before removing the intake maniford.
Otherwise, engine coolant may enter into the intake port from the vent holes of the clylinder head and this can cause problems in the engine combustion chambers.
4.
Install in the reverse order of removal.
   
Tighten the intake manifold bolts and nuts, in several passes as below.
Tightening torque
Step 1: 3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
Step 2: 26.5 ~ 31.4N.m (2.7~3.2kgf.m, 19.5~23.1lb-ft)
Step 3: Repeat 2nd step twice or more.

   
Fill the engine coolant after installing intake maniford and check coolant level.

    Components 1. Intake manifold

    Components 1. LH Exhaust manifold gasket2. LH Exhaust manifold3. LH Heat protector4. LH Exhaust manifold stay5. RH Exhaust manifold gasket6. RH Exhaust manifold7.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.

    Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0348