Kia Cadenza YG: Lighting System / License Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Disconnect the connector (B) after removing the license lamp assembly (A).
|
| 3. |
Turn the license bulb socket (A) counterclockwise to remove the bulb.
|
| Installation |
| 1. |
Install the bulb. |
| 2. |
Install the license lamp assembly. |
Inspection Overhead Console Lamp Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the center fascia panel (A) with hazard lamp switch. Apply the protective tapes to the center fascia panel and its related parts.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Description and Operation
Description System Operation Typically, lane departure warning is activated at a speed over 70 KPH, but suppressed in case of unintentional lane departure when driver do not operate turn signal. System Operation Conditions 1. User Conditions (1) When unintended lane departure is occured, warnings are generated.
Kia Cadenza YG 2016-2021 Service Manual: Description and Operation
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Oil Pump Components and Components Location
- General Information
- Engine Electrical System
- New on site
- Most important about car
