Kia Cadenza: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove box housing")
3.
Remove the passenger airbag mounting bolts (A).

4.
Disconnect the passenger airbag connector (A) and active vent connector (B).

5.
Remove the crash pad.
(Refer to Body - "Main crash pad assembly")
   
Replace the crash pad which is damaged while PAB is deployed.
6.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Install the crash pad.
(Refer to Body - "Main crash pad assembly")
5.
Tighten the passenger airbag mounting bolts.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-.ft)

6.
Connect the passenger airbag harness connector to the SRS main harness connector.
7.
Reinstall the glove box housing.
(Refer to Body - "Glove box housing")
8.
Reconnect the battery negative cable.
9.
After installing the passenger airbag (PAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Passenger Airbag (PAB) Module Components and Components Location
Components ...

Side Airbag (SAB) Module Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag b ...

Other information:

Kia Cadenza YG 2016-2025 Owners Manual: Air cleaner


Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Pull out the air cleaner cover. 2. Unlock by turning the locking lever downward. 3. Pu ...

Kia Cadenza YG 2016-2025 Service Manual: Receiver-Drier Repair procedures


Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged b ...

Copyright © www.kcadenzavg.com 2017-2025