Kia Cadenza: Charging System / Alternator Description and Operation

Kia Cadenza YG 2016-2025 Service Manual / Engine Electrical System / Charging System / Alternator Description and Operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

1. Brush
2. Drive belt pully
3. Rotor
4. Stator
5. Rectifier

Repair procedures
On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DT ...

Alternator Specifications
Specification ItemSpecificationRated voltage13.5V , 150ASpeed in use1,500 ~ 18,000rpmVoltage regulatorIC Regulator built in typeDefault regulated voltage (V) [COM terminal]14.0 ~ 15.5 (-35°C)14. ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: License Lamp Repair procedures


Removal 1. Disconnect the negative(-) battery terminal. 2. Disconnect the connector (B) after removing the license lamp assembly (A). 3. Turn the license bulb socket (A) counterclockwise to remove the bulb. Installation 1. Install the bulb. 2. Install the license lamp assembly. ...

Kia Cadenza YG 2016-2025 Service Manual: Components and Components Location


Components 1. Drive belt2. Drive belt tensioner3. Idler4. Crank shaft pulley5. Water pump pulley 1. Oil pump chain cover2. Oil pump sprocket3. Oil pump chain 4. Oil pump tensioner assembly5. Crankshaft oil pump sprocket6. Crankshaft RH chain sprocket7. RH Timing chain auto tensioner8. RH T ...

Copyright © www.kcadenzavg.com 2017-2025