Kia Cadenza: Maintenance / Battery
For best battery service
- Keep the battery securely mounted.
- Keep the battery top clean and dry.
- Keep the terminals and connections
clean, tight, and coated with
petroleum jelly or terminal grease.
- Rinse any spilled electrolyte from
the battery immediately with a
solution of water and baking soda.
- If the vehicle is not going to be
used for an extended time, disconnect
the battery cables.
Always read the following
instructions carefully when
handling a battery.
If any electrolyte gets into
your eyes, flush your eyes
with clean water for at least
15 minutes and get immediate
medical attention.
If electrolyte gets on your
skin, thoroughly wash the
contacted area. If you feel
pain or burning sensation,
get medical attention immediately.
An inappropriately disposed
battery can be harmful to the
environment and human
health. Dispose the battery
according to your local law(s)
or regulation.
The battery contains lead. Do
not dispose of it after use.
Please return the battery to
an authorized Kia dealer to
be recycled.
Never attempt to recharge the battery
when the battery cables are connected.
WARNING - Risk of electrocution
Never touch the electrical ignition
system while the vehicle is
running. This system works
with high voltage which can
shock you.
WARNING - Recharging
Battery
Never attempt to recharge the
battery when the battery cables
are connected.
WARNING - Battery lead
compound
Battery posts, terminals, and
related accessories contain
lead and lead compounds.
Wash hands after handling.
✽ NOTICE
If you connect unauthorized electronic
devices to the battery, the battery
may be discharged. Never use
unauthorized devices.
Recharging the battery
Your vehicle has a maintenance-free,
calcium-based battery.
- If the battery becomes discharged
in a short time (because, for example,
the headlamps or interior
lamps were left on while the vehicle
was not in use), recharge it by
slow charging (trickle) for 10 hours.
- If the battery gradually discharges
because of high electric load while
the vehicle is being used, recharge
it at 20-30A for two hours.
When recharging the battery,
observe the following precautions:
- The battery must be removed from
the vehicle and placed in an area
with good ventilation.
- Do not allow cigarettes, sparks, or
flame near the battery.
- Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin
gassing (boiling) violently or if the
temperature of the electrolyte of
any cell exceeds 120°F (49°C).
- Wear eye protection when checking
the battery during charging.
- Disconnect the battery charger in
the following order.
1. Turn off the battery charger main
switch.
2. Unhook the negative clamp from
the negative battery terminal.
3. Unhook the positive clamp from
the positive battery terminal.
- Before performing maintenance or
recharging the battery, turn off all
accessories and stop the engine.
- The negative battery cable must be
removed first and installed last
when the battery is disconnected.
Reset items
Items should be reset after the battery
has been discharged or the battery
has been disconnected.
- Auto up/down window
- Sunroof
- Trip computer
- Climate control system
- Driver position memory system
Blade inspection
Commercial hot waxes applied by
automatic car washes have been
known to make the windshield difficult
to clean.
Contamination of either the windshield
or the wiper blades ...
Tire care
For proper maintenance, safety, and
maximum fuel economy, you must
always maintain recommended tire
inflation pressures and stay within
the load limits and weight distribution
rec ...
Other information:
This system provides further
enhancements to vehicle stability
and steering responses when a vehicle
is driving on a slippery road or a
vehicle detects changes in coefficient
of friction between right wheels
and left wheels when braking.
WARNING - Tire/
Wheel size
When replacing tire ...
Diagnosis With GDS
1.
BSD system defects can be quickly diagnosed with the GDS. GDS
operates actuator quickly to monitor, input/output value and self
diagnosis.
2.
Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.
3.
Sele ...