| Component Location |

| 1. Driver power window switch 2. Door lock switch 3. IPM(Intelligent intergrated Platform Module) 4. Front door lock actuator | 5. Rear door lock actuator 6. Trunk lid open actuator 7. Assit power window switch |
Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to Body - "Front Door") 2. Remove the front door module.
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.