Kia Cadenza: Windshield Deicer / Description and Operation
		
		
		
Windshield deicer system prevent windshield wiper from 
freezing in the winter season. It consists of deicer in the lower part 
of windshield, switch and relay. IPM receives an input signal from the 
deicer switch, then controls relay. Operating condition is the same that
 of rear window defogger system.
Since the generator "L" is switched ON, if the deicer switch is ON, then deicer output is ON for 20 minutes.
   Component Location
1. Windshield deicer relay (Built-in engine room relay box)2. Windshield deicer switch (Rear glass defogger switch)3. Windshield deicer4. Deicer connector
 ...
   
 
   Inspection
1.
Remove the cowl top cover. (Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper motor linkage.
3.
Check for continuity between the terminals  ...
   
 
   Other information:
   OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of
 On Board Diagnostics (OBD) for vehicles sold in California beginning 
with the 1988 model year. The first phase, OBD-I, required monitoring of
 the fuel metering system, Exhaust Gas Recirculation (EGR) sy ...
   
   Inspection
First Seat Heater
1.
Check for continuity and measure the resistance between No.1 and NO.4 terminals.
No.DescriptionNo.Description1Heater (-)3NTC (+)2NTC (-)4Heater (+)
Standard value (Fabric / Leather)
Cushion : 1.04 Ω ± 10%
Back : 1.1 Ω ± 10%
Set : 2.14 Ω ± 10%
 ...