Kia Cadenza YG: Bumper / Front Bumper Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Bumper / Front Bumper Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
•
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting bolts, then remove the engine room air duct (A).

2.
After loosening the mounting bolts and clips, then remove the radiator grill upper guide (A).

3.
Remove the front bumper upper side mounting clips.

4.
Remove the front bumper lower side mounting clips.

5.
After loosening the front bumper side''s mounting screw, then disconnect the side''s.
   
•
Remove the front bumper by pulling up the side of the front bumper and then pull it out.
   
•
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

6.
Remove the front bumper cover.
(1)
Lift up the lower side of the front bumper cover (A).

(2)
Remove the front bumber cover (B) by pushing it rearward to release the locking pins (A) located upper side of the front bumper cover.

7.
Disconnect the fog lamp connector (A) and front bumper main connector (B).
[LH]

[RH]

8.
Installation is the reverse of removal.
   
•
Make sure the connectorare connected in properly.
•
Replace any damage clips.

    Components(1) 1. Front bumper cover2. Front bumper upper weatherstrip3. Radiator grill upper guide4. Front bumper side bracket [LH]5. Front bumper side bracket [RH] Components(2) 1.

    Components(1) 1. Rear bumper cover2. Rear bumper side bracket [RH]3. Rear bumper side bracket [LH]4. Tail trim cover Components(2) 1. Rear bumper beam assembly2.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0258