Kia Cadenza: Seat / Headrest
The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort.
The headrest not only provides comfort for the driver and front passenger, but also helps protect the head and neck in the event of a rear collision.
For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height of the center of gravity of an occupant's head. Generally, the center of gravity of most people's head is similar with the height of the top of their eyes.
Also, adjust the headrest as close to your head as possible. For this reason, the use of a cushion that holds the body away from the seatback is not recommended.
WARNING - Headrest removal/adjustment
- Do not operate the vehicle with the headrests removed. Headrests can provide critical neck and head support in a crash.
- Do not adjust the headrest height while the vehicle is in motion. Driver may lose control of the vehicle.
CAUTION
Excessive pulling or pushing may damage the headrest.
Easy access function
The system will move the driver's
seat automatically as follows:
• With smart key system
- It will move the driver’s seat rearward
when the engine start/stop
button is changed to the OFF
...
Adjusting the height up and down
To raise the headrest, pull it up to the
desired position (1). To lower the
headrest, push and hold the release
button (2) on the headrest support
and lower the headrest to the desired
pos ...
Other information:
Kia Cadenza YG 2016-2025 Service Manual: IMS Control Switch Repair procedures
Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Removal 1. Disconnect the negative (-) b ...
Kia Cadenza YG 2016-2025 Service Manual: Rear Door Repair procedures
Replacement Door Trim Replacement • Be careful not to scratch the door trim and other parts. • Put on gloves to protect your hands. 1. Using a screwdriver or remover, remove the rear door inside handle cap (A) and full handle cover (B). ...
