Kia Cadenza YG: Steering wheel / Heated Steering wheel Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Steering System / Steering wheel / Heated Steering wheel Repair procedures

Inpection
1.
Measure a resistance of NTC and Heated pad.
–
NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10% (25°C)
–
Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 Ω ± 10%
2.
Measure a temperature.
–
The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute
–
The temperature of wheel surface grip must keep 38°C ± 4°C after 25 minute
–
At that time switch on, all measure point (1~8)

    System Circuit Diagram Terminal Function HousingPinFunctionWire colorPadAGNDBackBHEATERYellowCNTC+Back / RedDNTC-BackRemotecontrolAGNDBackBBATRedCLEDGreenDSWITCHWhite

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0208