Kia Cadenza: Lighting / High beam operation
.jpg)
To turn on the high beam headlamp, push the lever away from you.The lever will return to its original position. The high beam indicator will light when the headlight high beams are switched on.
To turn off the high beam headlamps, pull the lever towards you. It will return to the normal (low beam) position when released.
To prevent the battery from being discharged, do not leave the lights on for a prolonged time while the engine is not running.
WARNING - High beams
Do not use high beam when there are other vehicles in front of your vehicle. Using high beam could obstruct the other driver’s vision.
.jpg)
To flash the headlights, pull the lever towards you. It will return to the normal (low beam) position when released. The headlight switch does not need to be on to use this flashing feature.
Lighting control
The light switch has a Headlight and
a Parking light position.
To operate the lights, turn the knob at
the end of the control lever to one of
the following positions:
(1) OFF position
(2) ...
High Beam Assist (HBA)
High Beam Assist that automatically
adjusts the headlamp range (switches
between high beam and low
beam) according to the brightness of
other vehicles and road conditions. ...
Other information:
Kia Cadenza YG 2016-2025 Service Manual: Smart Cruise Control Unit Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the front bumper. (Refer to Body - "Front Bumper") 3. Disconnect the smart cruise control unit connector (A). 4. Loosen the nuts (A) and bolt (B), and then remove the smart cruise ...
Kia Cadenza YG 2016-2025 Service Manual: High Pressure Fuel Pump Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops. 1. Turn the ignition swi ...
