Kia Cadenza: Windshield Wiper/Washer / Rain Sensor Description and Operation

Kia Cadenza YG 2016-2024 Service Manual / Body Electrical System / Windshield Wiper/Washer / Rain Sensor Description and Operation

Description

The Rain sensing windshield wiper system is a wiper system that, in addition to providing normal wiper functions off, mist, manual low speed, manual high speed, and wash, provides automatic control of automatic intermittent automatic low, and automatic high speeds.

When the ignition key is in the ON position, the rain sensor will be activated.

System Function

Basic Principle

Emitted Beam from luminosity diode is reflected entirely against the windshield exterior, and then turn into photo diode.

If there is water on the windshield exterior, beam separates optically, and the degree of remained beam is measured in the photo diode.

What there is water in the windshield, it means beam is not reflected all, so the degree of lost beam indicates the degree of glass surface wet.

Rainsensor consist of two luminosity diode, two photo diode, optic fiber and coupling pad.

Operation Control

Wiper ECU transmits the signal as a rainsesor, and then the rainsensor perceives the rainwater to transmit to the wiping order wiper ECU, wiper ECU controls the wiper motor according to the signal.

Contact Influence

The rainsensor can malfunction due to following condition

•	Contamination of the measurement surface.

•	Air bubbles between the windshield and the coupling pad contact surface.

•	The movement of coupling pad by vibration.

•	Damaged wiper blade.

Operation Condition

In case that engine starts under wiper switch AUTO, rainsensor activates after once wiper operation to inform the driver that the system is under AUTO.

In case that the rainsensor doesn''t work or malfunction, it is needed manual wiper switch operation by the driver.

Rain Sensor Schematic Diagrams

Circuit Diagram ...

Rain Sensor Repair procedures

Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor inpu ...

Other information:

Kia Cadenza YG 2016-2024 Service Manual: Repair procedures

Refrigerant System Service Basics Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system. – Air conditioning refrigerant or l ...

Kia Cadenza YG 2016-2024 Owners Manual: Manual heating and air conditioning

The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected. 1. Start the engine. 2. Set the mode to the desired position. ...