Kia Cadenza: Maintenance / Scheduled maintenance service
Follow the Normal Maintenance
Schedule if the vehicle is usually
operated where none of the following
conditions apply. If any of the following
conditions apply, follow the
Maintenance Under Severe Usage
Conditions.
- Repeated driving short distance of
less than 5 miles (8 km) in normal
temperature or less than 10 miles
(16 km) in freezing temperature
- Extensive engine idling or low
speed driving for long distances
- Driving on rough, dusty, muddy,
unpaved, graveled or salt-spread
roads
- Driving in areas using salt or other
corrosive materials or in very cold
weather
- Driving in heavy dust condition
- Driving in heavy traffic area
- Driving on uphill, downhill, or
mountain road repeatedly
- Towing a trailer or using a camper,
or roof rack
- Driving as a patrol car, taxi, other
commercial use of vehicle towing
- Driving over 106 mph (170 km/h)
- Frequently driving in stop-and-go
condition
If your vehicle is operated under the
above conditions, you should
inspect, replace or refill more frequently
than the following Normal
Maintenance Schedule. After 120
months or 150,000 miles continue to
follow the prescribed maintenance
intervals.
The following lists are vehicle checks
and inspections that should be performed
by the owner or an authorized
Kia dealer at the frequencies
indicated to help ensure safe,
dependable operatio ...
The following maintenance services must be performed to ensure good emission
control and performance.
Keep receipts for all vehicle emission services to protect your warranty. Where
both mileage ...
Other information:
Checking the brake fluid level
Check the fluid level in the reservoir
periodically. The fluid level should be
between MAX (Maximum) and MIN
(Minimum) marks on the side of the
reservoir. Before removing the reservoir
cap and adding brake fluid, clean
the area around the reservoir cap
...
Removal
1.
Remove the center console assembly.
(Refer to Body - "Floor console")
2.
Remove the air duct (A).
3.
Disconnect the shift cable (A) and then remove the shift
cable (B) after pressing the shift cable socket (C) in the direction of
"F".
Inst ...