Kia Cadenza: Driver Attention Warning (DAW) / System malfunction
When the “Check Driver Attention
Warning (DAW) system” warning
message appears, the system is not
working properly. In this case, take
your vehicle to an authorized Kia
dealer and have the system
checked.
WARNING
- Driver Attention Warning is
not a substitute for safe driving
practices, but a convenience
function only. It is the
responsibility of the driver to
always drive cautiously to
prevent unexpected and sudden
situations from occurring.
Pay attention to the road
conditions at all times.
- The driver, who feels fatigued,
should take a break, even
though there is no break suggestion
by Driver Attention
Warning.
✽ NOTICE
Driver Attention Warning utilizes
the front view camera sensor on the
front windshield for its operation.
To keep the front view camera
sensor in the best condition, you
should observe the followings:
- Do not disassemble camera temporarily
for tinted window or
attaching any types of coatings and
accessories. If you disassemble a
camera and assemble it again, take
your vehicle to an authorized Kia
dealer and have the system checked
to need a calibration.
- Do not locate any reflective
objects (i.e. white paper, mirror)
over the dashboard. Any light
reflection may cause a mal-function
of Driver Attention Warning.
- Pay extreme caution to keep the
front view camera out of water.
- Do not arbitrarily disassemble the
camera assembly, nor apply any
impact on the camera assembly.
• Playing the vehicle audio system
at high volume may offset the
Driver Attention Warning warning
sounds.
For more information of front
view camera, refer to “Lane
Keeping Assist (LKA)”.
✽ NOTICE
Driver Attention Warning may not
properly operate with limited alerting
in the following situations:
- The system will not operate for
about 15 seconds when restarting
the engine or initializing the front
view camera such as rebooting,
etc.
- The lane detection performance is
limited. (For more information,
refer to "Lane Keeping Assist
(LKA)" in this chapter.)
- The vehicle is violently driven or is
abruptly turned for obstacle
avoidance (e.g. construction area,
other vehicles, fallen objects,
bumpy road).
- Intentionally frequent lane cut-in
Driver Attention Warning enters the
ready status and displays the
‘Standby’ screen in the following situations.
- Driving speed remains over 110
mph (180 km/h). ...
This system reminds the driver the
leading vehicle’s driving departure
after stopping.
function setting
With the vehicle ON, Leading Vehicle
Departure Alert function turns on
and gets read ...
Other information:
Circuit Diagram - ESC (1)
Circuit Diagram - ESC (2)
Circuit Diagram - ESC (3)
Circuit Diagram - ESC (4)
Circuit Diagram - ESC (5)
ESC connector input/output
Connector TerminalSpecificationPin NoDescriptionStandardPremium2931IGNITION1(+)High level of wake up voltage : 4.5V < V < 16 ...
Inspection
1.
Ignition "ON"
2.
Using the scan tool.
3.
Emit intensive light toward photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and reduce with lower intensive light.
1. Auto Light Signal2. Auto Light GND3. Ph ...