Kia Cadenza: Brake system / Warning messages

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Brake system / Warning messages

Parking brake automatically engaged

When the EPB is applied from Auto Hold, a warning will sound and a message will appear.

AUTO HOLD turning Off! Press brake pedal

When the conversion from Auto Hold to EPB is not working properly a warning will sound and a message will appear.

✽ NOTICE

When this message is displayed, the Auto Hold and EPB may not operate. For your safety, depress the brake pedal.

Press brake pedal to deactivate AUTO HOLD

If you do not apply the brake pedal when you release the Auto Hold by pressing the [AUTO HOLD] switch, a warning will sound and a message will appear.

AUTO HOLD conditions not met. Close door, hood and trunk

When you press the [AUTO HOLD] switch, if the driver’s door or engine hood are not closed or the or the trunk is opened, a warning will sound and a message will appear on the LCD display. At this moment, press the [AUTO HOLD] button after closing the driver’s door and engine hood and trunk.

Cancel
To cancel the Auto Hold operation, press the Auto Hold switch. The AUTO HOLD indicator will go out. To cancel the Auto Hold operation when the vehicle is at a standstill, press the Auto Hol ...

Anti-lock brake system (ABS)
ABS (or ESC) will not prevent accidents due to improper or dangerous driving maneuvers. Even though vehicle control is improved during emergency braking, always maintain a safe distance betw ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Immobilizer Control Unit Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1. Install the immobilizer cont ...

Kia Cadenza YG 2016-2025 Service Manual: Height Sensor Repair procedures


Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector. ...

Copyright © www.kcadenzavg.com 2017-2025