Kia Cadenza: Infotainment system / Antenna
.jpg)
Glass antenna
Your vehicle uses a glass antenna to
receive both AM and FM signals.
Shark fin antenna
The shark fin antenna will receive the
transmit data.
CAUTION
- Do not clean the inside of the
rear window glass or quarter
glass with a cleaner or use a
scraper to remove any foreign
deposits as this may cause
damage to the antenna elements.
- Avoid adding metallic coating
such as Ni, Cd, and so on.
These can interfere with
AM/FM reception.
- To prevent damage to the rear
glass antenna, never use sharp
instruments or window cleaner
containing abrasives to clean
the window. Clean the inside
surface of the rear glass window
with a piece of soft cloth.
- When putting a sticker on the
inside surface of the rear window,
be careful not to damage
to the rear glass antenna.
- Do not put sharp instruments
nearby the rear glass antenna.
- Tinted rear window may affect
the proper functioning of the
antenna.
WARNING - Distracted
driving
Driving while distracted can
result in a loss of vehicle control
that may lead to an accident,
severe personal injury, and death.
The driver's primary responsibility
is in the safe and legal operation
of a vehicle, and use of any
handheld devices, other equipment,
or vehicle systems which
take the driver's eyes, attention
and focus away from the safe
operation of a vehicle or which
are not permissible by law should
never be used during operation
of the vehicle.
✽ NOTICE
If you install an after market HID
head lamp, your vehicle’s audio and
electronic device may malfunction. ...
You can use an USB port to plug in
an USB.
✽ NOTICE
When using a portable audio device
connected to the power outlet, noise
may occur during playback. If this
happens, use the power sour ...
Other information:
Warning And Caution Labels
1. Radiator cap caution2. Fan caution3. Battery caution
Battery Caution Label
Warning / Caution Label (Cont''d)
A.Keep lighted cigarettes and all other flames or sparks away from the battery.
B.Wear eye protection when charging or working near a battery. A ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the floor mat in the trunk.
3 ...