Other information:
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp
assembly, replace the turn signal lamp bulb (B) after removing the trim
cover (A) in the trunk.
3.
Remove the nuts (4EA).
4.
Remove the r ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the floor mat in the trunk.
3 ...