Kia Cadenza: Windows / Power windows

Kia Cadenza YG 2016-2025 Owners Manual / Features of your vehicle / Windows / Power windows

The ENGINE START/STOP button must be in the ON position for power windows to operate. Each door has a power window switch that controls the door’s window. The driver has a power window lock switch which can block the operation of rear passenger windows.

The power windows can be operated for approximately 30 seconds after engine is turned off. However, if the front doors are opened, the power windows cannot be operated even within the 30 second period.

If the window cannot be closed because it is blocked by objects, remove the objects and close the window.

✽ NOTICE

While driving with the rear windows down or with the sunroof in an open (or partially open) position, your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch (2.5 cm). If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

CAUTION

Do not install any accessories in the vehicle that extend into the open window area. Such objects will impact the proper function of the Automatic reversal "jam protection" feature.

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window ...

Window opening and closing
The driver’s door has a master power window switch that controls all the windows in the vehicle. To open or close a window, press down or pull up the front portion of the corresponding sw ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: CVVT Oil Control Valve (OCV) Description and Operation


Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...

Kia Cadenza YG 2016-2025 Service Manual: Cooling Fan Repair procedures


Removal and Installaton Cooling Fan Assembly 1. Disconnect the battery negative terminal. 2. Remove the air duct (A). 3. 3. Loosen the upper hose fixing bolt (A), and disconnect the fan motor connector (B).     The radiator hoses are still connected. 4 ...

Copyright © www.kcadenzavg.com 2017-2025