Kia Cadenza: Features of your vehicle / Rear View Monitor (RVM)
.jpg)
.jpg)
Rear View Monitor will activate with
the Engine Start/Stop button is
turned ON and the shift lever in the R
(Reverse) position.
This system is a supplemental system
that shows behind the vehicle
through the rearview display mirror
while backing-up.
- This system is a supplementary
system only. It is the responsibility
of the driver to always check the
inside/outside rearview mirrors and
the area behind the vehicle before
and while backing up.
- Always keep the camera lens
clean. If lens is covered with foreign
matter, the camera may not
operate normally.
WARNING - Backing &
using camera
Never rely solely on the rear view
monitor. You must always use
methods of viewing the area
behind you including looking
over both shoulders as well as
checking all three rear view mirrors.
Due to the difficulty of
ensuring that the area behind
you remains clear, always back
up slowly and stop immediately
if you suspect that a person, and
especially a child, might be
behind you.
Electronic Stability
Control (ESC) Indicator
Light
This indicator light illuminates:
Once you set the ENGINE
START/STOP button to the ON
position.
- It illuminates for approximatel ...
Surround View Monitoring is not a
substitute for proper and safe parking
procedures. Surround View
Monitoring may not detect every
object surrounding the vehicle.
Always drive safely and ...
Other information:
Removal and Installation
[LH]
1.
Disconnect the LH front and rear heated oxygen sensor (HO2S) connector.
(Refer to Fuel System - "Heated Oxygen Sensor (HO2S)")
2.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Muffler")
3.
Remove the cooling fan assembly.
(Refe ...
1. Press and hold the button (1) and
(3) simultaneously.
2. The indicator (4) is turned continuously
ON in orange for about 10
seconds.
3. Then the indicator (4) color
changes to Green and flashes rapidly.
Release the buttons once the
green indicator flashes.
4. Now HomeLink button ...