Kia Cadenza: Auto hold / Set up

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Brake system / Auto hold / Set up

1. With the driver's door, engine hood closed, fasten the driver's seat belt or depress the brake pedal and then press the Auto Hold button. The white AUTO HOLD indicator will come on and the system will be in the standby position.

2. When you stop the vehicle completely by depressing the brake pedal, the AUTO HOLD indicator changes from white to green.

3. The vehicle will remain stationary even if you release the brake pedal.

4. If EPB is applied, Auto Hold will be released.

Leaving

If you press the accelerator pedal with the shift lever in D (Drive) or manual mode, the Auto Hold will be released automatically and the vehicle will start to move. The indicator changes from green to white.

WARNING

When driving off from Auto Hold by depressing the accelerator pedal, always check the surrounding area near your vehicle.

Slowly depress the accelerator pedal for a smooth launch.

Auto hold
The Auto Hold maintains the vehicle in a standstill even though the brake pedal is not depressed after the driver brings the vehicle to a complete stop by depressing the brake pedal. ...

Cancel
To cancel the Auto Hold operation, press the Auto Hold switch. The AUTO HOLD indicator will go out. To cancel the Auto Hold operation when the vehicle is at a standstill, press the Auto Hol ...

Other information:

Kia Cadenza YG 2016-2025 Owners Manual: Panoramic sunroof


If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can be operated for approximately 30 seconds after the ENGINE START/STOP button is in the OFF position. However, if the driver’ ...

Kia Cadenza YG 2016-2025 Service Manual: Head Lamps Repair procedures


Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. (If the polarity are changed, low beam doesn''t lighten) (4) Check the bu ...

Copyright © www.kcadenzavg.com 2017-2025