Kia Cadenza: Manual heating and air conditioning / Air intake control

Kia Cadenza YG 2016-2024 Owners Manual / Features of your vehicle / Automatic climate control system / Manual heating and air conditioning / Air intake control

This is used to select the outside (fresh) air position or recirculated air position.

To change the air intake control position, push the control button.

Outside (fresh) air position

With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected.

Recirculated air position

With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected.

Prolonged operation of the heater in the recirculated air position (without air conditioning selected) may cause fogging of the windshield and side windows and the air within the passenger compartment may become stale.

In addition, prolonged use of the air conditioning with the recirculated air position selected will result in excessively dry air in the passenger compartment.

Temperature control
The temperature will increase to the maximum (HI) by raise the toggle switch to the extreme up. The temperature will decrease to the minimum (Lo) by depress the toggle switch to the extreme ...

Fan speed control
The fan speed can be set to the desired speed by operating the fan speed control switch. To change the fan speed, raise the switch for higher speed or depress the switch for lower speed. To ...

Other information:

Kia Cadenza YG 2016-2024 Service Manual: Windshield Wiper-Washer Switch Repair procedures


Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Wiper Switch Washer SwitchRemoval 1. Remove the steering column upper and lower shrouds after removing 3 screws. 2. Remov ...

Kia Cadenza YG 2016-2024 Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures


Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure the resistance between power terminal (10) and signal terminal (2). Specification : 5.1 ± ...

Copyright © www.kcadenzavg.com 2017-2024