Kia Cadenza: Electronic Parking Brake (EPB) / Releasing the parking brake

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Brake system / Electronic Parking Brake (EPB) / Releasing the parking brake

To release the EPB (Electronic Parking Brake), press the EPB switch while doing the following:

1. Place the ENGINE START/STOP button in the ON position.

2. Press the brake pedal.

3. The shift lever must be in P (Park).

4. Make sure the brake warning light goes off.

To release EPB (Electronic Parking Brake) automatically:

• Shift lever in P (Park)

With the engine running depress the brake pedal and shift out of P (Park) to R (Reverse) or D (Drive).

• Shift lever in N (Neutral)

With the engine running depress the brake pedal and shift out of N (Neutral) to R (Reverse) or D (Drive).

• Automatic Transmission

1. Close the driver's door, engine hood and trunk.

2. Fasten the driver's seat belt.

3. Start the engine.

4. Depress the accelerator pedal while the shift lever is in R (Reverse), D (Drive) or Sports mode.

Make sure the brake warning light goes off.

✽ NOTICE

Do not follow the above procedure when driving on a flat level ground. The vehicle may suddenly move forward.

CAUTION

EPB (Electronic Parking Brake) may be automatically applied when:

✽ NOTICE

For EPB (Electronic Parking Brake) equipped vehicles with [AUTO HOLD] function used while driving, if the ENGINE START/STOP button has been turned OFF, the EPB will be engaged automatically. Therefore, [AUTO HOLD] function should be turned off before the ignition button is turned off.

Electronic Parking Brake (EPB)
Applying the parking brake To apply the EPB (Electronic Parking Brake): 1. Depress the brake pedal. 2. Pull up the EPB switch. 3. Make sure the warning light comes on. Also, the EPB is app ...

System warning
If you try to drive off by depressing the accelerator pedal with the EPB applied, but the EPB doesn't release automatically, a warning will sound and a message will appear. If th ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Surround View Monitoring Unit Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") 3. Remove the SVM unit (B) after disconnecting the connectors (A) and mounting bolts. Installation 1. Install the SVM unit. 2. Install the glove box h ...

Kia Cadenza YG 2016-2025 Service Manual: Repair procedures


Inspection Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal. The horn should make a sound. If the horn fails to make a sound, replace it. Horn Relay Inspection 1. Remove the horn relay (A) from the engine room relay box. 2. There should be continuity ...

Copyright © www.kcadenzavg.com 2017-2025